Stove Bright M230™ is an easy-to-use sealant for all aspects of maintenance and installation of pellet stoves or gas-burning systems. Seal metal flues for wood and coal burning stoves, or use it to adhere a replacement gasket to your stove door channel. It is perfectly capable of resisting intermittent peak temperatures of 1100°F, but was designed for use with a continuous operating temperature of 900°F. This high performance sealant is black, but turns a charcoal color once it is completely dry. Cover this sealant with high temperature paint so that it blends in perfectly with the surrounding surface! Now available in a 12-cartridge contractor pack!
- Please be sure to wear rubber gloves and eye protection during application of this product. Protect your work area from accidental spills with a tarp or drop cloth. Thoroughly remove all debris and foreign matter from the surface to be sealed.
- To use:
- Insert cartridge in the caulking gun and cut the tip at an angle to desired diameter (1/8"). Lay a bead and drag the material at a 45° angle in desired area
- Allow material to air dry.
- Heat cure at 200°F for approximately 1.5 hours.
|Size per each:
||10.1 fl.oz (299 mL) cartridge
|Cartridges per case:
||Black (but dries charcoal)
||900°F (482°C) continuous
Features & Benefits:
- Fits into standard caulking guns for easy application.
- Can be covered with high temperature paints.
- Will not encourage rust when applied to bare metal.
- Air dries and cures with heat (at 200°F for approximately 1.5 hours).
- Single solution as a high temperature sealant and gasket adhesive!
- Stands up to intermittent peak temperatures of 1100°F.
Silicone & Caulking Tips: DiY like a Pro!
- Product cartridge fits into a standard caulking gun. For clean application, cut the cartridge tip near the end, at an approximate 45° angle.
- Ensure that the working surface is clean, dry, and free of debris. Have some damp cloths or a roll of paper towels within reach. Lay down newspaper to protect carpet/flooring from possible drips.
- To lay a professional bead, hold the caulking gun at 45°. Spin the cartridge tube so the longest part of your tip is aligned with the top side of the caulking gun.
- Beginning at the highest point of your working area, slowly and gently squeeze the trigger and drag the gun to lay an even bead (about 1/8").
- For a clean job, remember that "A little goes a long way!" Try to be consistent when laying a bead - you can always go back and add more material later.
- As you near the end of the working area, release the trigger (or press the release lever) to stop the flow of material.
- After applying the material, let it cure for the indicated amount of time (at room temperature) before using your appliance.