Free shipping within the continental United States!

Our glass and stove experts are here to help!

Call us today at 1-888-986-1535

Save 13%
Gray Fireplace Mortar

Not for exterior use. Apply 1/16 - 1/8" thick!

10.3 Fluid Ounce Gray Fireplace Mortar

List price: $15.99  
Price in points: 1399 points
Add to Wishlist


Fireplace mortar is essential for patching cracked or chipped fireplace refractory, or filling missing mortar joints. The A.W. Perkins brand is a trusted product that we highly recommend for this job! You can fire it immediately - the material requires 1200°F to strengthen the mortar to firebrick hardness. Once it is fully cured, it will withstand temperatures up to 2000°F! This high quality gray mortar is ideal for indoor applications.

Remember to check out our Silicone & Caulking Tips below to see if we have any suggestions to help make your DIY project easier. If you have any questions, we’re happy to help! Give Fast Replacement Glass a call at 1-888-986-1535.

  • To use:

    • Burn a low fire to dry the fireplace mortar.

    • Heat under extreme heat to cure.

    • This mortar is rated for indoor use only. 
    • For large repairs (exceeding 1/8" areas), a castable refractory cement is highly recommended.
Size: 10.3 fl oz cartridge
Color: Gray
Temperature Rating: 2000°F (1093°C)
Features & Benefits:
  • Meets ASTM E-136 and E72 non-combustability standards.
  • Versatile enough to patch firebricks or repair masonry on areas 1/8" or smaller.
  • Covers up to 99 feet - can be painted once fully cured!


How to caulk like  pro!Silicone & Caulking Tips: DiY like a Pro!

  1. Product cartridge fits into a standard caulking gun. For clean application, cut the cartridge tip near the end, at an approximate 45° angle.
  2. Ensure that the working surface is clean, dry, and free of debris. Have some damp cloths or a roll of paper towels within reach. Lay down newspaper to protect carpet/flooring from possible drips.
  3. To lay a professional bead, hold the caulking gun at 45°. Spin the cartridge tube so the longest part of your tip is aligned with the top side of the caulking gun.
  4. Beginning at the highest point of your working area, slowly and gently squeeze the trigger and drag the gun to lay an even bead (about 1/8"). 
  5. For a clean job, remember that "A little goes a long way!" Try to be consistent when laying a bead - you can always go back and add more material later.
  6. As you near the end of the working area, release the trigger (or press the release lever) to stop the flow of material.
  7. After applying the material, let it cure for the indicated amount of time (at room temperature) before using your appliance.



No posts found

Write a review
Last updated on August 23rd 2017.