Free shipping within the continental United States!
The 5 4/5 x 3 inch uncanned catalytic combustor CC-011 is designed to fit the Leader 2100C. With its honeycomb design, it features 25 cells per inch. Each and every cell is coated with precious platinum and palladium. Every nook and cranny of the cells are coated with these metals and they act as the catalysts. They cause the gases to burn at a lower temperature which presents them from escaping and becoming waste. A combustor is not a filter. While it does physically capture particles, the combustor deploys chemical catalysis to break apart the molecular structure of unburned particles. Smoke is converted into water vapor, carbon dioxide, and heat to make your wood burning stove capable of heating longer with less wood. Maintain the efficiency and top notch performance of your wood stove by replacing the catalytic combustor every 12,000 hours.
PLEASE NOTE: Your wood stove or fireplace will need a bypass damper in order to use a catalytic combustor. (When the exhaust temperature isn't high enough for a combustor to "light-off" the wood-smoke, the exhaust must have an alternate route to go until the combustor is hot enough to perform its function.)
Will I Need A Gasket For My Catalytic Combustor?
Combustors that have no stainless steel "can" must always be installed with a new expanding gasket. Uncanned combustors are manufactured with a CatGard (an expanding gasket that is wrappped around the combustor) at no extra charge. The factory ships the correct gasket already in place, with masking tape to hold the gasket in the proper position during installation.
Federal law requires any EPA-certified catalytic wood stoves be operated with combustors to reduce air pollution over the entire life of the stove.
|Cells Per Inch:||25|
Combustors are guaranteed to contain sufficient catalytic precious metals (platinum and/or palladium) formulated and properly applied to conform to requirements of the U.S. Environmental Protection Agency for certified wood-burning products, and when installed in USA are warranted for structural integrity for five years or 12,000 hours burn-time, whichever comes first, when correctly installed and maintained. Failure due to incorrect use, including with fuels other than dry natural wood, is excluded.
REMEDIES UNDER THIS WARRANTY Manufacturer will replace a defective combustor, free of charge, for the first 90 days following the date of original purchase. After the first 90 days, replacement will be at the following discount:
Estimated Lead Time:
5-10 Business Days.
Product can not be shipped to Canada!
Feel free to contact us if you have any questions or need more information about this product. For general information, or inquiries not related to this product, please contact us directly instead. Thank you!
No posts found