Model CC-111

7 x 9 x 2 Inch Canned Catalytic Combustor CC-111

Price in points: 28300 points
Add to Wishlist


The 7 x 9 x 2 inch canned catalytic combustor CC-111 fits several different models made by Blaze King. Use this catalytic combustor replacement for your King, KE 1107, KEI 1200 or 1300, or KEJ 1101. Operating your catalytic heating application with an old combustor can have some adverse affects! Not only does this contribute to a loss of heat coming from your stove, but it also allows for uncontrolled heat within the firebox. This can lead to cracking or permanent damage of your wood stove or fireplace. The ceramic-honeycomb combustor converts smoke into additional heat, carbon dioxide and water vapor. You'll find 16 metal coated cells per inch that act as the catalyst. Combustors should be replaced every 12,000 hours of use. Replacing a worn out canned catalytic combustor brings new life to your stove, while promoting better air quality due to the reduction in creosote! 

PLEASE NOTE: Your wood stove or fireplace will need a bypass damper in order to use a catalytic combustor. (When the exhaust temperature isn't high enough for a combustor to "light-off" the wood-smoke, the exhaust must have an alternate route to go until the combustor is hot enough to perform its function.)

  • Will I Need A Gasket For My Catalytic Combustor?
    Canned Combustors: original equipment catalytic combustors that are "canned" (wrapped with a welded stainless steel strip) should be replaced by new combustors that are also canned. Observe that canned combustors have a gasket material sandwiched between the can and the ceramic honeycomb.

    Depending on the particular stove design, heating applications with canned combustors may, or may not, require an additional gasket outside the can for a secure fit inside the stove. In some cases the combustor assembly consists of two or more pieces. In this event, a gasket should be used between the individual pieces for a good fit.

  • THE LAW:
    Federal law requires any EPA-certified catalytic wood stoves be operated with combustors to reduce air pollution over the entire life of the stove.

Model: CC-111
Height: 2.0 Inches
Width: 7.0 Inches
Length: 9.0 Inches
Cells Per Inch: 16




Manufacturer Warranty:

Combustors are guaranteed to contain sufficient catalytic precious metals (platinum and/or palladium) formulated and properly applied to conform to requirements of the U.S. Environmental Protection Agency for certified wood-burning products, and when installed in USA are warranted for structural integrity for five years or 12,000 hours burn-time, whichever comes first, when correctly installed and maintained. Failure due to incorrect use, including with fuels other than dry natural wood, is excluded.

REMEDIES UNDER THIS WARRANTY Manufacturer will replace a defective combustor, free of charge, for the first 90 days following the date of original purchase. After the first 90 days, replacement will be at the following discount:

  • Year 1 — 50% of original price paid
  • Year 2 — 40% of original price paid
  • Year 3 — 30% of original price paid
  • Year 4 — 20% of original price paid
  • Year 5 — 10% of original price paid
  • Year 6 — Replacement at current retail price.

Estimated Lead time

Estimated Lead Time:

5-10 Business Days.

Product can not be shipped to Canada!


Fits Stove Type:
  • Blaze King KE 1107
  • Blaze King KEI 1200
  • Blaze King KEI 1300
  • Blaze King KEJ 1101
  • Blaze King King

Total Size

Height (Rounded Up To The Nearest Inch):
  • 2 Inches
Diameter (Rounded Up To The Nearest Inch):
  • 7

Product Question

Feel free to contact us if you have any questions or need more information about this product. For general information, or inquiries not related to this product, please contact us directly instead. Thank you!


No posts found

Write a review
Last updated on October 20th 2017.